Alumina Ceramic Roller Connection

Time:2018/9/10 16:37:20 Click on:

There are many ways to connect alumina ceramic rollers, which are based on the specific conditions of the ceramic tubes. A simple connection is described below.

The first thing to do is to cut the pipe. The pipe must be cut according to the required length. Then we should pay attention to the time when the pipe is broken. If the force is too large, it will cause the ceramic riser to be out of round. The burr is removed. When the pipe is cut, the burr must be removed, otherwise the seal will be cut.

Then mark the line. In order to allow the alumina ceramic roller to be completely inserted into the tube socket, at this time, the insertion length must be marked at the tube end; then the sealing ring should be correctly installed in the groove of our ceramic riser tube. . For this, we need to insert the tube into the socket of the pipe and wait for the crimp.

Finally, what we need to do for the connection of alumina ceramic rollers is crimping and inspection. When crimping, pay attention to the convex part of the pipe to be placed in the concave groove of the mold. For the jaw and the pipe axis, it must be vertical. After the above steps are completed, we should note that it uses a special gauge to check the dimensions of our crimps.

alumina ceramic roller ， fused silica roller for tempering furnace ，high temperature alumina ceramic roller ，Company website： http://www.ceramicroller.net/ 

• Previous：High Temperature Alumina Ceramic Roller Company Introduces You To What Is High Frequency Porcelain
• Next：Three Ways Of Wearing Fused Silica Roller For Tempering Furnace Elbow